Suite · You own the quality system
Inspection plans, nonconformities, calibrated instruments and competence on one record — the quality system, whatever the shop makes or tests.
Request a demoThe ITP is in one spreadsheet, calibration due-dates in another, nonconformities in a third, competence in a drawer — so the real state of the system is never in one place.
Cost: Days lost pulling it together, and a finding waiting for the next audit
An NCR is raised in a message, dispositioned in a call and "closed" when someone remembers; the corrective action is never tied to what actually caused it.
Cost: Repeat findings, and no evidence the CAPA ever worked
A gauge falls out of date or a qualification expires, and the first you hear of it is when the work it touched gets questioned.
Cost: Results and certificates put in doubt after the fact
Modules in this suite
Each writes to the same job, so nothing is entered twice. You buy the suite — every module is included.
A hold point is only a control if somebody is stopped by it. On paper it is a row in a spreadsheet that gets ticked afterwards.
A nonconformance raised in welding, found by NDT and dispositioned by engineering usually lives in three systems and agrees with itself in none of them.
Every gauge has a certificate and a due date, and the work it touches is only valid while it's in date — but the due dates live in a spreadsheet nobody's sure is still maintained.
A superseded WPS reaches the floor because the controlled document existed but the control didn't — and the sealed handover pack is still gathered by hand at the end.
Who is qualified for what, and what is about to lapse, lives in a drawer of certificates instead of one competence record you can actually read.
The dossier is assembled by hand in the last weeks of a job, from folders and inboxes, by the people who can least afford the time.
One or several, job by job. The regime is a layer on the same backbone — not a different product.
The common denominator. EN 1090-2 requires it at every execution class — the level rising with the class (EXC1 → ISO 3834-4, EXC2 → 3834-3, EXC3/4 → 3834-2) — the pressure world adopts it as the welding quality system, and ASME Section IX is its qualification counterpart outside Europe.
Read the UNI EN ISO 3834 pillar →The route to placing a structural component on the European market. EN 1090-1 governs conformity assessment and factory production control; EN 1090-2 governs how the steel is actually executed, in four execution classes.
Read the EN 1090 pillar →The European route for pressure equipment above 0.5 bar. Risk categories drive the conformity assessment module, and from category II upward the welding personnel and procedures must be approved by a notified body or recognised third-party organisation.
Read the PED 2014/68/EU pillar →The railway sector's own welding regime. Certification levels CL1 to CL3 track the highest weld performance class a manufacturer produces; CL4 covers organisations that do not weld but design, procure, maintain or operate. Welding coordination requirements are stricter than the general case.
Read the EN 15085 pillar →The American route, and the code most often specified on work outside the European Union — dominant in North America and the Gulf. Procedure and performance qualification through essential, supplementary essential and nonessential variables.
Read the ASME BPVC Section IX pillar →Who runs it
Same suite — the sector only changes the code you work to. Open yours for the pains and the regime that apply.
Quality is a function, not a trade. The person who owns it might sit in a fabrication shop, an NDT house or a certification body — the job is the same: make sure the work can be proven, and that the system saying so holds up to an audit.
Worgify Quality gives that function its own record. Inspection plans, nonconformities, calibrated instruments, competence and document control sit on one backbone and feed the same handover dossier the rest of the platform builds. The modules here also appear inside the trade suites — this is the same work, seen from the quality system rather than the shop floor.
